FAQ’S

The shaft is 32 inches long including the hourglass tip. The shafts carbon fiber body has an OD that is .57 inch and will accept all grips that fit a traditional steel putter shaft with a .60 butt shaft end. The bore hole of the hourglass shaft tip piece is .37

The shaft's body is made of hi strength multi layer custom roll wrapped carbon fiber and the hourglass shaped tip insert is made of anodized 7075 hi strength aircraft grade aluminum.

Yes, the shaft is conforming.

The swing feel and total weighting of your putter will stay very very close to your current putters weighting/feel. The design of the balance point putter shaft was to add a layer of green reading utility to the putter shaft while improving the putter shaft's performance over steel, all without changing or impacting the overall weighting and feel the golfer has specifically chosen in their putter. By keeping the balance point of your putter at the same point of your existing putter, the overall weighting and swing weight feel change will be very very minimal. In extreme cases, the weighting difference/swing feel difference may amount to the same feeling as holding two quarters in your hand while you swing your existing putter and then swing your putter without those quarters in your hand.

Hourglass recommends that a club fitter/installer complete the installation, but for those skilled in golf club repair/fitting/regriping, they should be able to install the shaft.

Yes, you can order the balance point shaft directly through the balance point putting website.

The shaft should be able to be used with almost all putters. The shaft's bore hole size fits putters shafts with parallel tips. See size dimension FAQ for more detailed tip size info.

Hourglass golf is currently working on expanding it's dealer/demo network. As we are a start up, our Atlanta area location is the only location for demo of the product.